Nintendo Switch Crystal Dock - Classic and OLED version

Print-in-place
No Support Needed
Both Switch OLED AND Switch CLASSIC versions are included.

Do you want a fantastic way to customize your Switch Dock?
Here's the Nintendo Switch Crystal Dock Decor!
Super easy to print in any color to go along with your TV setup!

The model was carefully designed not to obstruct the AirFlow of the Switch or the cables at the back. Note that the USB ports will be covered, though.
The two crystal parts snap and stay put together nicely!

⭐⭐⭐⭐⭐
IMPORTANT NOTE:
If you want to legally sell 3D prints based on my designs, please become a Patreon on my page:
www.patreon.com/holoprops

All of my Designs are covered by a Creative Commons Non-Commercial License. Sale of prints using my designs are the sole right of myself, the designer, and my active Patreons to do so. Please understand every design is days of work and multiple prototype prints to ensure quality.

Happy printing!

FIX (Dec2022):
Reuploaded Part B
* Minor transformations to realign some crystals that could disturb the docking.
* Consolidate one area that was a weak spot

To get the best out of the STL file, please follow these guidelines:
• No support is needed for any parts. Everything is Print-in-Place.
• Layer Height 0.2mm
• Nozzle 0.4mm
• Recommended infill 15%.
• Recommended Infill Pattern: Gyroid or Cubic

• Prepare and clean your bed for excellent adhesion.
• Do not print over 50 mm/s. A lower speed like 40 or even 30 mm/s will always produce better results.
• Make sure your bed is correctly leveled. Then check again :D
• Try to hide the seam and place it where nobody will pay attention.
• Make sure your printing and bed temperatures are adequate for the filament you are about to use.