Inline Finger Skates

With these inline skates you will have moments of great fun. They are made to jump, spin and slide on the edges of anything. Of course, you will have to practice the tricks before showing them to someone.

In the files you will find two sizes, child and adult.

Check out the video I made for you:
https://youtu.be/eWlKsFPfVHQ

Do you want to sell 3d prints of my models? On my Patreon page you can subscribe and get a seller's license:
https://www.patreon.com/RodMuzac

Follow me on Instagram:
https://www.instagram.com/rodmuzac/

Print-in-place model

No supports needed.

Make sure you have good adhesion to the print bed, if necessary use an additive, in my case I use a bit of strong hold hairspray.

I suggest a print speed around 60mm/s for most printers. Three line walls and z-hop activated (0.2mm z-hop height is ok).

Currently many printers handle higher speeds with total reliability. You know the capabilities of your machine. ;-)

I usually use a little bit of silicone spray for the moving parts. It works very well!

See the video!
https://youtu.be/eWlKsFPfVHQ