Cute Mushroom Cable Holder

Print-in-place
No Support Needed

I'm super excited to share with you the Cute Mushroom Cable Holder! 🍄

This cute and functional model is perfect for organizing your cables and adding some fun to your desk. It has a lot of cool features:

No supports are required as the cap can be screwed directly into the body. This model is available in two versions: Unibody for Multicolor printing or Detached.

This can accommodate cables between 2mm and 4mm in diameter. Notably, it is an ideal fit for iPhone cables.

Additionally, there is an indentation located beneath the model to accommodate an optional 2mm double-sided sticker for adhering it to a surface.

Finally, a secret compartment inside can securely accommodate up to five AA batteries or anything you like.

⭐⭐⭐⭐⭐
IMPORTANT NOTE:
If you want to sell 3D prints based on my designs legally, please become a supporter on the platform of your liking:
🔵Thangs - www.thangs.com/designer/Holoprops (http://www.thangs.com/designer/Holoprops)
🟠Patreon - www.patreon.com/holoprops

All my Designs are covered by a Creative Commons Non-Commercial License on Cults 3D. The sale of prints using my designs is the sole right of myself, the designer, and my active supporters to do so. Please understand every design is many days of work and multiple prototype prints to ensure quality.

Happy printing!

To get the best out of the STL file, please follow these guidelines:
• No support is needed to print this frog. Everything is Print-in-Place.
• Layer Height 0.2mm
• Nozzle 0.4mm
• Recommended infill 15%.
• Recommended Infill Pattern: Gyroid or Cubic

• Prepare and clean your bed for excellent adhesion.
• Make sure your bed is correctly leveled. Then check again :D
• Try to hide the seam and place it where nobody will pay attention.
• Make sure your printing and bed temperatures are adequate for the filament you are about to use.