Creality K1 roof riser with openable windows (ventilation)

Creality K1 roof riser with openable windows

When printing with PLA, not good the closed chamber. So I always took the roof off and opened the door on K1 printer. The printer was left open for days and dust got inside, and the removed printer cover was always in the way. So I planned a riser with openable windows on three sides of printer.
This way, you don't have to remove the roof only when replacing the filament.
Of course, due to high-temperature printing, I simply close the windows.

Print the parts according to whether the filament runout sensor is on the back (original) or on the right. The hinges of window and wall are "print in place", does not require assembly!

PRINT:
Original place of runout:
4pc K1roof_corner.stl
3pc K1roof_wall_door.stl
1pc K1roof_wall back-hole.stl

Runout on right side:
3pc K1roof_corner.stl
1pc K1roof_corner-hole.stl
3pc K1roof_wall_door.stl
1pc K1roof_wall back-full.stl

ASSEMBLY:
1., Remove the original screws from the corners of the printer.
2., Secure the printed corner elements with the same screws. (If the runout sensor is on the right side, put the corner with hole element there).
3., Press in the walls between the corners using the joint rail. I planned these tight, carefully tapping them into place.

OPTIONAL:
There is a small hole on the windows and on the frame opposite it. Small 4x2mm round magnets can be glued into this (or a magnet in the frame and little iron screw in the window), but the windows close well even without them.

FREE BONUS:

CREALITY K1 RUNOUT SENSOR BASE ON RIGHT SIDE:
https://cults3d.com/en/3d-model/tool/creality-k1-k1-max-runout-sensor-base-on-right-side

CREALITY K1 SIDE FAN COVER, PROTECTOR
https://cults3d.com/en/3d-model/tool/creality-k1-side-fan-cover-protector

PTFE FUNNEL - LOADER
https://cults3d.com/en/3d-model/tool/ptfe-funnel-loader

Filament holder on right side with bearings:
https://www.printables.com/model/615714-creality-k1-filament-holden-on-right-side/files

Material: any FDM
Layer high: 0,2mm
Wall: 3
Tob/bottom: 4
Infill: 50%
Raft & Brim: NO
Support: yes, >45 degree (look in pictures)
Orientation: see on pictures