Burger n' Chip Clip

I had been working on another project and developed a print-in-place clip that would hold fabric. For some reason the design made me think of a hamburger, maybe I was just hungry.

This burger has teeth and opens and closes with a satisfying 'snap'
It will happily hold a chip bag closed.

Also included are parts to glue in 4x 8mm diameter by 2mm thick magnets in case you'd like to put it on the fridge when not in use.

If you would like to sell prints of this, consider becoming a patreon:
https://www.patreon.com/user?u=108780200

0.4mm nozzle, 0.2 layer height (0.1) should work if you prefer.
No supports needed for any of the parts.
A small amount of glue will be needed for assembly.
All models should be properly oriented for FDM printing
The clip has some very tight tolerances and may need to be loosened slightly after printing.

All parts should snap together, with the exception of the 'Tomato' part, it needs to be glued to the top of the bun